TLILIC0014 Licence to Operate a Slewing Mobile Crane (up to 100 tonnes)

$1,950.00

Our C1 (Slewing) Crane course specifies the outcomes required to operate a slewing mobile crane (up to 100 tonnes) for licensing purposes.

Category:

About

Our C1 (Slewing) Crane course specifies the outcomes required to operate a slewing mobile crane (up to 100 tonnes) for licensing purposes. It encompasses the requirement for the up to100 tonnes licence. This course requires the operator to plan the work, conduct routine checks, set up crane, transfer loads, mobile loads and shut down and secure the crane.

Duration: 4 Days – dependant on experience

Fees: Full payment is required upon booking to confirm your place and can be made via eftpos in person or over the phone.

Delivery: Face-to-Face

Assessment methods: Written Questions and Practical

  • Introduction and Legislation.
  • OHS Regulations. OHS Act.
  • Definition of a slewing mobile crane.
  • Code of practice (prevention of falls from heights).
  • Load Calculations.
  • Use and application of fibre ropes. Flexible steel wire ropes, chains, synthetic slings and lifting gear.
  • Requirements for certification under the National Standards.
  • Communication skills.
  • Safe Slinging and Lifting practices.
  • Selection and use of mobile cranes AS 2550.
  • The identification of workplace hazards and the application of appropriate hazard control measures.
  • Be able to establish the mass and dimensions of different loads to be lifted.
  • Learning, understanding and the application of appropriate methods of communication with the crane operator.
  • Plan a lift in conjunction with the crane operator and site supervisor.

All candidates that successfully complete the course will be issued with a statement of attainment for a nationally recognised unit of competency:

TLILIC0014 -Licence to operate a Slewing Mobile Crane (up to 100 tonnes).

  • Must have good verbal and written comprehension of the English language;
  • Must be over 18 years of age;
  • Must bring copy of valid & current Worksafe Dogging and C6 ticket (pre-requisite);
  • Must have evidence of 2 years of operating experience greater than 20T and up to 60T crane;
  • Must bring 2 forms of ID (1 x photo ID, 1 x other ID). Photo ID may include drivers licence, passport, proof of age card. Non-photo ID may include credit card, bank card, medicare card;
  • Must have good general health and fitness for practicals (eg. physical work);
  • Must have basic mathematical skills and knowledge to work out formulas;
  • Must wear long sleeved shirt, long leg pants and steel cap boots;
  • Must hold a USI (unique student identifier) number.

General requirement information

This course can be offered in-house at our premises in Kewdale, Western Australia. The course can also be delivered on-site at your location if preferred.